Gases and Gas Accessories
Labconco™ AtmosPure™ Re-Gen Gas Purifiers
Automatic regeneration process completed in as little as 13 hours while unattended
MilliporeSigma™ Supelco™ domnick hunter™ Zero Air Generator
Produces a continuous supply of air that is virtually free of hydrocarbons, including methane
MilliporeSigma™ Supelco™ Molecular Sieve 5A Moisture Traps
Efficiently remove moisture and heavy hydrocarbons from compressed air, electrolytically produced hydrogen, house nitrogen, or other gases with high moisture or hydrocarbon content
Economy Moisture-Removing Trap, 400 cc, MilliporeSigma™ Supelco™
The clear polycarbonate tubes contains a mixture of Molecular Sieve 13X and Molecular Sieve 4A with indicating capability. Because room air may permeate through the polycarbonate tube, this trap should not be used with carrier gas streams.
MilliporeSigma™ Supelco™ Purge/Trap C
Specific configurations available for a variety of instruments
Synthware™ Vacuum and Inert Gas Manifold with Hollow Glass Stopcocks, Front Left/Right, Rear/Left Connection
No retention clip needed. Hollow stopcocks held in place by vacuum.
Synthware™ Vacuum and Inert Gas Manifold with Hollow Glass Stopcocks, Front Right, Rear Left Connection
No retention clip needed. Hollow stopcocks held in place by vacuum.
Synthware™ Vacuum and Inert Gas Manifold with Solid Glass Stopcocks, Front Right/Left, Rear Right/Left Connections
Stainless Steel Retention Clips to ensure stopcocks stay in place.
Synthware™ Vacuum and Inert Gas Manifold with Hollow Glass Stopcocks, Front Left/Right, Rear Right Spcherical Connection
No retention clip needed. Hollow stopcocks held in place by vacuum.
Synthware™ Vacuum and Inert Gas Manifold with Hollow Glass Stopcocks
No retention clip needed. Hollow stopcocks held in place by vacuum.
Synthware™ Argon/Nitrogen Gas Manifold with PTFE Stopcocks
With 14/20 outer joint at the center to fit a rubber septum for keeping syringes under an inert environment cutting down on the number used.
Synthware™ Vacuum Manifold, Double Bank
Vacuum Manifold, Double Bank with forward facing high vacuum valves allow easy operation of manifold inside of a fume hood. Main parts are spaced 100 mm center to center. Adapter components or stoppers are available and have to be ordered separately.
Synthware™ Vacuum Manifold with PTFE Stopcocks, Left Side Connection
PTFE stopcocks eliminate the need for grease.
Synthware™ Vacuum or Inert Gas Manifold, Double, Front Right, Rear Left Connection
General purpose double bank manifold for use with vacuum and inert gas.
Synthware™ Single Vacuum Manifold with No. 15 O-ring
Four ports are spaced 100 mm center to center, with 0 to 8 mm high vacuum valves mounted on 45° angle to the operator for easy access.